EF Fittings
Electro Fusion (EF) Coupler
EF Couplers are are an integral part of every PE installation; It's strength is as good as butt fusion welding often advantageous. Some of these couplers are available up to 25Bar strength.
OD 20mm - 800mm
SDR11 SDR17 (SDR9)
Request more information
Electro Fusion (EF) 45/90 Degree
The Electro Fusion (EF) Elbow is used for all changes of direction in the HDPE pipe system. Available in 45 Degree, 90 Degree, and in some cases 30 Degree.
OD 32mm - 225mm
SDR11 (PN16)
Request more information
Electro Fusion (EF) Tee
The Electro Fusion (EF) Tee is used for all changes of direction in the HDPE pipe system where branching is required.
OD 32mm - 225mm
SDR11 (PN16)
Request more information
Electro Fusion (EF) Tapping Saddle
The Electro Fusion (EF) Pressure Tapping Tee is used for branches of unpressurised and pressurised pipelines. (Outlet from OD 20mm - 63mm depending on Mains diameter)
OD 40mm - 225mm (Mains)
SDR11 (PN16)
Request more information
Electro Fusion (EF) Spigot Saddle
Electro Fusion (EF) Spigot Saddles are used for tapping of depressurised gas - and waterpipes as well as for pressure drainage. Outlet spigot for use with EF couplers. (Branch Sizes from OD63mm - 160mm depending on Mains diameter). Please contact us with your requirements
OD63mm - 630mm (Mains)
SDR11 (PN16)
Request more information
Electro Fusion (EF) Reducer
The EF Reducer is applied for immediate reduction within the pipe system. Please contact us with your requirements
OD 160mm - 20mm
SDR11 (PN16)
Request more information
Electro Fusion (EF) Threaded Transition Fitting
ELectro Fusion (EF) Transition Fittings are threaded joints as an adaptor from a steel/brass pipe with internal or external thread to a HDPE pipe. Joint on the part of HDPE by EF Coupler. (0.5" - 2.5" BSP male & female threaded outlet) Please contact us for full details.
OD 32mm - 63mm (with varying Threaded Outlets)
SDR11 (PN16)
Request more information
Electro Fusion (EF) End Cap
The Electro Fusion (EF) End Cap is used to shut off or blank outlets in the HDPE pipe system.
OD 20mm - 225mm
SDR11 (PN16)
Request more information